TRCW 20 & 24 Series

Wheel Offset Disk Harrow

For use with tractors in the 375 – 600hp range

FEATURES

  • For deep plowing, plowing in heavy trash, mixing and aerating.
  • Heavy duty proven design with rugged construction welded for maximum strength and rigidity.
  • Adjustable disk blade scrapers.
  • Equipped with Timken dual tapered roller bearings.
  • High gang carrier design to prevent trash build up and clogging.
  • Heavy duty torsion tube for distributing the torque generated by the front right gang.
  • Hydraulic tongue leveler with nitrogen accumulator.
  • Up to 1088lbs (494kg) of weight per disk blade depending on model.
  • Standard 13” (330mm) depth of penetration with 36” (914mm) diameter disk blades.
  • Optional 15” (381mm) depth of penetration with 42” (1.07m) diameter disk blades.
TRCW2024Series1.jpg
TRCW2024Series2.jpg
TRCW2024Series3.jpg
TRCW2024Series1.jpg
TRCW2024Series2.jpg
TRCW2024Series3.jpg

Specifications

Series TRCW Wheel Offset Disk Harrow

20” (508mm) disk spacing; 2-1/2” (64mm) round axles; Equipped with Timken dual tapered roller bearings

Model Number Width of Cut ft/in (m) Number of Disks Suggested Engine Horsepower Weight Per Disk lbs (kg) Net Weight lbs (kg)
TRCW‐20 16’‐0” (4.9) 20 375 – 450 1088 (494) 21,750 (9866)
TRCW‐24 19’‐6” (5.9) 24 450 – 600 1006 (456) 24,150 (10,954)

*Engine horsepowers are suggested ranges and vary according to soil conditions and weight added to harrow. Per ASAE
S290.1 – Width of cut will vary with gang angle and disk blade diameter.
NOTE: This harrow requires hydraulic control. Two rear tractor hydraulic circuits required for harrow operation.

Standard Equipment

  • 36” (914mm) diameter x 1/2” (13mm) thick, cutout (notched) deep concavity disk blades.
  • Hydraulic tongue leveler with nitrogen accumulator.
  • Adjustable disk blade scrapers.
  • Heat treated alloy steel gang axles.
  • Heavy duty fabricated steel spacer spools.
  • Heavy duty bearing wear plates.
  • New industrial tires – 4 each TRCW-20 and TRCW-24: 21.5 x 16.1 – 14 ply.
  • Hydraulic control group includes cylinders, hose holders, and hoses with fittings to reach rear of tractor.
  • Drawbar jack stand and safety chain.

Optional Equipment

  • 42” (1.07m) diameter x 1/2” (13mm) thick, cutout (notched) deep concavity disk blades.
  • Cylinder rod stops.
  • Light group.
  • Oil Bath Bearings